Vehicles
Sections
170 not categorized PORSCHE 944 ELYCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 GT3 2003-05 (includes uncategorized and accessory items) 91134732204EQ The symptoms of a worn tie rod end include, clunking, rattling and squeaking when turning, poor alignment and premature tire wear. Have the rod ends inspected when servicing your suspension and proactively change them when noticing any of the symptoms. Quality European aftermarket replacement designed to perform like the original. Sold individually. Left or right-side fitment. 2 necessary per car.
$64.90
Make a selection BES95B05040SK + 15 hp & + 18 tq gain. - 2.5 tubing (63.5mm). - 4 x 4 (101mm) round tips. - 8.5 lb. Weight savings over OEM mufflers. - German v2a - x5crni18-10 - 1.4301 stainless steel for improved durability. - does not interfere with emissions and will not trigger the check engine light. - ecu programming (software) is not necessary. - electronic valve controller must be removed from the OEM unit and added to our muffler. - made in Germany. Please note: this muffler is a direct replacement the macan turbo (95b) model which comes with a single electronic exhaust valve on the passenger side. This is the very 1st aftermarket muffler for the macan 95b turbo that includes a valve like the factory system. This allows our system ...(choose a part on the right to read more)
$4,544.10
Make a selection 915302911161 This ring and pinion is manufactured in Germany to our specifications using case hardened steel (18crnimo7-6). Our specifications include special heat treatment which is extremely wear resistant, contains a tough inner core, includes high tensile strength and exhibits lower noise levels. Sold as a set. 1 necessary per car. Technical info: setting for the drive train is on the bevel gear and not as usual on the ring gear.
$5,408.70
Make a selection 91450194310A This is the weld on hook that holds the 914-6 oil line prone. Never available as a separate part, this is direly needed for any 914-6 conversion
$31.27
Make a selection 92834102733ATK By ordering this part number you get after previous sending in your wishbone overhauled with new silent blocs back. Should it not be repairable, we will inform you immediately.
$342.10
Make a selection 96434101807ATK Unsure about installing replacement bushings and bearings? Send us your control arm and we will properly recondition and install the bushings and bearings for you. The reconditioning process includes full inspection of your track control arm to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we properly install our OEM front control arm bushings, part # FVD3419991. They are made with 65 shore rubber like the original control arms. Please note: each control arm is remanufactured in Germany, so the lead times can vary. If we cannot remanufacture your control arm we will notify you as soon as we can. Arrangements can be made for...(choose a part on the right to read more)
$418.00
Make a selection 93042340109 The clutch cable disengages the clutch in order to safely shift the transmission. A failing clutch cable can produce the same symptoms as a failing clutch, so we recommend replacing the cable / cables when installing a new clutch. High-quality OEM replacement, designed to perform like the original. We source this part in Germany to ensure quality, reliability and precise fitment. This part number supersedes part numbers 930 423 401 02 / 03 / 05. Sold individually. 1 necessary per car. Please note: this fits the 1978 930 3.3 l turbo model from chassis # 930 880 0192 on.
From $27.00
Make a selection 930602702XATK The cdi or hkz as it is known in Germany, is the high-voltage condenser ignition control unit. Aging cdi / hkz units lead to deterioration of performance with time. A failing unit's symptoms include a fluctuating tach, stalling, loss of power to the ignition coil and no start situations, leaving you stranded. Send us your original cdi / hkz and German technicians with many years of experience will completely remanufacture it to new specifications. This is not a repaired unit like many of our competition offer, this is a completely remanufactured unit using new upgraded components. The remanufacturing process includes: disassembly inspection and cleaning complete diagnosis (including oscillogram) on a test benc...(choose a part on the right to read more)
$823.90
Make a selection 94463190500 European flachbau / slant nose models came with this position light. It sits just inside of the front turn signal. They suffer from cracks caused by road debris, and should be replaced as soon as a crack is noticed. Replace yours with this high-quality hella replacement. We source this part in Germany to ensure quality, reliability and precise fitment. Sold individually. 2 necessary per car. Please note: bulb is not included, please order part # 90063110590 separately.
From $11.85
Make a selection 95504480103 Group 2 + 3 seat for children from 33 - 80 lbs. / approx. 3,5 to 12 years of age. . Porsche child seats can be fitted into position quickly and securely using the standard north american latch fastening system in conjunction with the Porsche child seat fastener system which needs to be installed through your authorized Porsche dealer. Telescopic bars on the child seat lock into place between the backrest and the seat and hold it firmly to the passenger seat. Child seats may only be used in the Boxster, 911 or Cayman on the passenger seat in conjunction with the child seat fastener system. To avoid the risk of injury from a deploying airbag, never place a child age 12 or under in a front seating position without...(choose a part on the right to read more) General FitmentACCESSORY
$303.15
Make a selection 96433102200RATK Unsure about installing a replacement bushing? Send us your trailing arm and we will properly recondition and install the bushing for you. The reconditioning process includes full inspection of your trailing arm to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we properly install our rear clubsport trailing arm bushings, part # FVD3310212291. Our rear trailing arm bushings contain rubber inserts with a shore hardness value of 85, like what is used on rennsport models. They offer rs style handling characteristics, superior durability and are still forgiving enough for street use. When reconditioning the trailing arms, we als...(choose a part on the right to read more)
$672.10
Make a selection 96434101707ATK Unsure about installing replacement bushings and bearings? Send us your control arm and we will properly recondition and install the bushings and bearings for you. The reconditioning process includes full inspection of your track control arm to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we properly install our OEM front control arm bushings, part # FVD3419991. They are made with 65 shore rubber like the original control arms. Please note: each control arm is remanufactured in Germany, so the lead times can vary. If we cannot remanufacture your control arm we will notify you as soon as we can. Arrangements can be made for...(choose a part on the right to read more)
$418.00
Make a selection BBI9912020003 The bbi autosport 997 & 991 GT3 / rs exhaust side bypass is a direct replacement for the factory primary side mufflers. The primary mufflers are weigh approximately 44 pounds total while the bbi pipes are 4 pounds in comparison. For durability and protection against corrosion, each system is meticulously tig welded using 304 aerospace grade stainless tubing with lower carbon content. The result is a substantial reduction in weight behind the rear axle which significantly improves handling and less restriction to produce a much more aggressive exhaust note.
$950.00
Make a selection 99334101802ATK Unsure about installing replacement bushings and bearings? Send us your control arm and we will properly recondition and install the bushings and bearings for you. The reconditioning process includes full inspection of your track control arm to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we will properly install original control arm bushings. . Please note: each control arm is remanufactured in Germany, so the lead times can vary. If we cannot remanufacture your control arm we will notify you as soon as we can. Arrangements can be made for its return to you. We do not offer a core exchange on this part. Sold individually....(choose a part on the right to read more)
$418.00
Make a selection 9645558320070EQ We source these door pulls in Germany to ensure that the material and stitching are made as closely to the originals as possible. Sold individually.
$35.81
Make a selection 96455525100NEQ Attention to detail is what distinguishes our parts from the competition. We source these door handles in Germany to ensure that they are made as closely to the original as possible. Sold individually.
$99.94
Make a selection 99312301452ATK Our k-16 remanufactured turbo is cost competitive and is a direct replacement. Simply send us your original k16 turbochargers and a borg warner / kkk certified technician will remanufacture your turbo. The remanufacturing process includes full inspection to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we will replace the turbine wheels, thrust bearings, install new seals, recondition the internals and high speed balance the turbo. This ensures reliability and superior performance for many years to come. The remanufacturing is done on an exchange basis only. You must send us your original k16 turbocharger. After receiving y...(choose a part on the right to read more)
$2,194.50
Make a selection 992CAT With over 25+ years of Porsche air and water-cooled experience, fabspeed motorsport usa offers a great enhancement for your stock exhaust or aftermarket exhaust on your Porsche 992 Carrera. Using only the highest quality helical valves imported directly from the u.k., our system eliminates any risk of failing exhaust valves. Helical limited in great britain supplies the world's very best exhaust valves to Porsche, ferrari, lamborghini, mclaren, aston martin, and other hypercar manufacturers. Other cheap aftermarket exhaust valves are not able to handle the heat produced by a rear or mid-engine car and are guaranteed to fail, break and rattle. Helical u.k. Imported exhaust valves are bullet-proof and never fai...(choose a part on the right to read more)
$5,245.95
Make a selection 99312301352ATK Our k-16 remanufactured turbo is cost competitive and is a direct replacement. Simply send us your original k16 turbochargers and a borg warner / kkk certified technician will remanufacture your turbo. The remanufacturing process includes full inspection to ensure proper operation after the remanufacturing process. We then disassemble, degrease and completely clean it. Once fully prepared, we will replace the turbine wheels, thrust bearings, install new seals, install new waste gates, recondition the internals and high speed balance the turbo. This ensures reliability and superior performance for many years to come. The remanufacturing is done on an exchange basis only. You must send us your original k16 turboc...(choose a part on the right to read more)
$2,194.50
Make a selection 96455583200LIL Attention to detail is what distinguishes our parts from the competition. We source these door pulls in Germany to ensure that the material and stitching are made as closely to the originals as possible. This is a shade similar to the original rs lila (German). Sold individually.
$18.70
Make a selection ADVWSSD3XL Perfect gear to show off your tuner of choice at a windy track day or race event. This German made, wind and water proof soft shell jacket is available in black or white. It includes grey color contrasts with the FVD logo stitched in red on the collar, left chest and right arm. There are plenty of pockets with waterproof zippers to safely store personal items and electronics.
$148.50
Make a selection 964555251000EQ Attention to detail is what distinguishes our parts from the competition. We source these door handles in Germany to ensure that they are made as closely to the original as possible. Sold individually.
$95.46
Make a selection ADVWSSDL Perfect gear to show off your tuner of choice at a windy track day or race event. This German made, wind and water proof soft shell jacket is available in black or white. It includes grey color contrasts with the FVD logo stitched in red on the collar, left chest and right arm. There are plenty of pockets with waterproof zippers to safely store personal items and electronics.
$148.50
Make a selection 99611601534 Made in Germany by sachs to original specifications. Oem disc. 240 mm with torsion springs. Max torque: 313 lb/ft (425 nm) weighs: 4.4 lbs. (1.99 kg) discs with torsion springs function as a vibration damper between the engine and gearbox. They effectively lessen the harshness felt during re-engagement.
$518.10
Make a selection ADVWSWH3XL Perfect gear to show off your tuner of choice at a windy track day or race event. This German made, wind and water proof soft shell jacket is available in black or white. It includes grey color contrasts with the FVD logo stitched in red on the collar, left chest and right arm. There are plenty of pockets with waterproof zippers to safely store personal items and electronics.
$148.50
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |